<form id="frzzj"></form>

<form id="frzzj"></form>
      <form id="frzzj"></form>

        <address id="frzzj"></address>

          <form id="frzzj"></form>
          此處為可編輯區
          Your present location:Home >> News Center >> Media Focus >> The daily use of the clutch maintenance to see 6 things no matter not to trample

          The daily use of the clutch maintenance to see 6 things no matter not to trample

          Number of visits: Date:2016-06-16 10:59

          Chu network news: "automobile clutch." This is because the clutch on the car in normal driving, is in a state of close engagement, the clutch should not slip, when driving is in addition to the vehicle starting and shifting and low speed brakes need to step on the clutch pedal, other time is not nothing to step on the clutch, or put a foot on the clutch pedal. First, it is very easy to cause clutch slip, clutch disc ablation and other phenomena, and the second will lead to the clutch pressure spring annealing and other failures, but also lead to the cost of oil, car, and increase the cost of driving, etc.. Of course, the foot long time on the clutch can lead to fatigue, so it is difficult to grasp the intensity of the clutch. So, how to maintain the clutch to extend the life of automobile parts?

          1. Due to the separation bearing long-term exposure of the work, lubrication condition is very poor, so the tractor every 300 to 500 hours after should be separated bearing removed, wash with clean diesel, flexible rotation, and then put into the container is provided with a butter heating, until the butter permeability for bearing full, to be cooled and solidified to remove installed on.

          2. The separation claw and bearing cover spiral bevel should be regularly cleaned and lubricated with oil or grease, and often to the small oil hole in the separation of the oil droplets on the separation claw and separation claw seat.
          Third, clutch friction plate, active plate and pressure plate stained with oil or rust should be apart to remove or oil, and gasoline or kerosene to clean, dry after loaded.

          3. Clutch friction plate, active plate and pressure plate stained with oil or rust should be apart to remove or oil, and gasoline or kerosene to clean, dry after loaded.

          4. Cleaning or replacement of the clutch bearings, should be coated with butter, and to the side of the dust cover to the clutch, not to install anti - oil to prevent the inflow of the clutch, so that the clutch.

          5. Regular adjustment of the clutch control mechanism, remove dirt, tighten all connection bolts, according to the provisions of the clutch pedal shaft.

          6. Such as the discovery of the friction plate exposed rivet head, crack, broken, large area of burning and the thickness of each piece of friction is less than 3.4 mm thickness, should replace the new friction plate.

          TypeInfo: Media Focus

          Keywords for the information:

          此處為可編輯區
          LinkedIn Pinterest Facebook Twitter Addthis
          香蕉视频18禁免费